octane render serial number

They may be able to tell you which state the car came from.
Thank you very much for an answer and have a nice day.You'll have to remove the passenger's seat, which is bolted in place.I have the body off and I"m well on the way, but I do not know what extent to go on the sterring box because when I drove the car the sterring was not bad except for the little bit of play.The earlier years were as much as two inches shorter. . If the gasket fails, rain water gets inside the horn and rusts the electrical connections.Any help is appreciated, George From: Larry Pearson: SoCal Chapter Advisor: I have this same problem with my 1960 Corvette and 1949 Plymouth from time to time.




If its a tight trans, use the GM manual trans fluid (more like 30w). .These are accessed from under the dash on the inside of the Corvette. .That in a full speed shift I bent both top leaves of the rear springs. .Very respectfully, Wayne From: Noland Adams, Founding President of sacc: Wayne, lets start with what we know.Models covered in this manual: 2000 Polaris Virage TX, 2000 Polaris SLX, 2000 Polaris Pro toy story 3 game demo 1200, 2000 Polaris Genesis, 2000 Polaris Genesis FFI.Loosen the jam nut and turn the adjustment screw in or out till you achieve minimum free play then retighten the jam nut.I have tried to come up with his name, and it seems his first name was Kermit.